Wireless BACnet modernizes HVAC control at Memorial City Mall, Houston
When the wired LON control system serving Memorial City Mall began to fail, the project team used W-BACnet to modernize controls across 94 rooftop units. The completed installation used 6 W-BACnet DIN rail gateways and approximately 90 W-BACnet DIN rail devices, while allowing each rooftop unit to be retrofitted and brought back online in four man-hours without subcontractors.
Project partners: ACIS Innocative Solutions, Building Controls & Solutions and LumenRadio
The existing LON system served rooftop HVAC equipment for the mall’s common areas. Across the 1.7 million-square-foot shopping center, the units were spread across a large, exposed roof rather than arranged along one convenient cable route.
A conventional replacement would have required communication cabling, conduit and raceways across substantial distances and multiple roof levels, adding considerable material and installation work. Each additional run would have meant more material to carry, install, support and protect in an environment exposed to weather and work by other contractors.
The project team therefore planned the retrofit as a wireless installation from the start. The replacement needed to minimize new rooftop infrastructure while providing reliable communication across a large, distributed installation, without extending a new communication backbone between all 94 rooftop units.


A wireless BACnet infrastructure
The building automation network was connected through a Contemporary Controls IP router. A communication cable was run from the router to the first rooftop unit, where a DIN rail-mounted W-BACnet gateway established the connection to the wireless network.
From that point, W-BACnet carried BACnet MS/TP communication wirelessly between the rooftop units serving the mall’s common-area air-conditioning system.
The W-BACnet devices and extended-ambient Distech ECB-203 controllers were installed in ventilated Altelix enclosures suitable for the rooftop environment. The team could pre-fabricate the enclosures and bring prepared units directly to the equipment instead of building each assembly from scratch on the roof.
Deployment included:
- 6 W-BACnet DIN rail gateways
- Approximately 90 W-BAC DIN rail nodes
- 5 dB puck antennas
- 94 controlled rooftop units
- Extended-ambient Distech ECB-203 controllers
- Ventilated Altelix enclosures

six devices configured as gateways and the rest as nodes.

Faster installation and reliable operation
The wireless approach reduced the physical infrastructure required on the roof while enabling faster, repeatable installation. Each rooftop unit could be retrofitted and brought back online in four man-hours. This included mounting a new enclosure, removing and replacing the wiring and devices, and completing the connection without subcontractors.
Pre-fabricating the enclosures allowed the team to spend its time on the roof connecting and commissioning equipment rather than extending conduit and communication cable between widely separated units. As a result, more equipment could be brought online during each work shift.
The completed installation also has a smaller physical footprint, with less cabling and fewer components exposed on the roof. Since commissioning, it has delivered a near-zero failure rate, with no callbacks caused by devices going offline.
By using wireless communication, we were able to pre-fabricate enclosures and retrofit more equipment online in a work shift without needing miles of cabling. The failure rate has been near zero and there have been no callbacks due to offline devices.
Mike Daley, Branch Manager, ACIS Innovative Solutions
A possible next step: Remote Diagnostics
The installation has not yet been evaluated with W-BACnet Remote Diagnostics. With supported W-BACnet products upgraded to firmware 4.3.0, wireless network diagnostics can be exposed as standard BACnet objects and imported into the BMS.
For a site with equipment distributed across a large roof, information such as network health, node status and performance could support remote troubleshooting before someone is sent onto the roof.
Using W-BACnet, Memorial City Mall modernized control across 94 rooftop units with less physical communication infrastructure on the roof and a repeatable, pre-fabricated installation method.
