[1.0.6.0]
- Added CRMX2 support
- Added support for Linking key
- Added support for universe name
- Universe name and universe color can generate interrupt when changing
- Fixed a bug that caused device name not being saved and updated properly when written via SPI.

[1.0.5.0]
- Device label register can now be read/written.
- Fixed issue where som transmitters could appear as clones - note: this may require relinking receivers after updating 

[1.0.4.0]
- Fixed a case where some transmitters at high output power caused a high packet loss.
- Fixed a bug with DMX streams with higher refresh rates than 200Hz.
- Fixed intermittent reboot issue when using DMX from BLE in TX mode
- Added generic RX/TX service, allowing for BLE to communicate with SPI interface
- Added a BLE connections status bit in BLE_STATUS register in SPI interface.

[1.0.3.0]
- Added RDM over SPI in RX mode
- Added DMX output from BLE in TX mode
- Improved sending of wireless DMX data when running from BLE DMX data source in TX mode.
- Added configurable DMX hold on loss of radio link.
- Added support for RGB RF Link LED and RGB Paired LED.  
- Stopped unlinking from interrupting an ongoing linking
- Stopped linking from interrupting an ongoing unlinking
- Added PRODUCT_ID register to SPI register map
- Make sure the IRQ is high for at least 10us to enable slow MCUs to detect the pulse.
- Fixed bug in transmitter where garbage data in could cause receivers to drop link.
- Fixed bug that could cause IRQ singal to get stuck in low state introduced in 1.0.2.3.
- Fixed possible crash with new send scheme when using BLE in TX mode
- Fixed bug that caused glitches when DMX is present on CRMX link and connecting from a BLE DMX source.
- Fixed bug that could cause TimoTwo to freeze upon reboot if using RGB status LED driver

[1.0.1.5]
- Fixed flex selection pin input not switching mode properly.

[1.0.1.0]
- Added support to allow the CRMX Toolbox app to link/unline 
- Fixed bug that could cause the changing of PIN code to fail
- Fixed local DMX output at XLR from BLE service when in RX mode (allowing direct app control of a fixture).

[1.0.0.8]
- Firmware update is now faster

[1.0.0.7]
- First production release
