[1.0.6.0]
- Added CRMX2 support
- Added support for Linking Key (not yet available in Toolbox App)
- Transmit device name as universe name when in TX mode

[1.0.5.0]
- Fixed issue where som transmitters could appear as clones - note: this may require relinking receivers after updating

[1.0.4.0]
- Fixed an issue where some transmitters at high output power caused a high packet loss.
- Fixed a bug with DMX streams with higher refresh rates than 200Hz.
- Fixed intermittent reboot issue when using DMX from BLE in TX mode

[1.0.3.0]
- Added DMX output from BLE in TX mode
- Improved sending of wireless DMX data when running from BLE DMX data source in TX mode.
- Added configurable DMX hold on loss of radio link.
- Stopped unlinking from interrupting an ongoing linking
- Stopped linking from interrupting an ongoing unlinking
- Fixed bug causing the Moonlite to potentially freeze upon reboot.
- Fixed bug in transmitter where garbage data in could cause receivers to drop link.
- Fixed bug that caused glitches when DMX is present on CRMX link and connecting from a BLE DMX source.
- Fixed bug with controlling the last LED in signal strength

[1.0.2.0]
- Fixed issue with button presses sometimes being missed in TX mode.
- Fixed bug that could cause Moonlite to shut down if button was kept pressed after power-on.
- Fixed bug that caused Moonlite to power back up if button was kept pressed after powering it off.
- Fixed a timing issue that could cause Moonlite to freeze.
- Increased visibility on the blue BLE mode blink.
- Added heartbeat blink to indicate that the unit is on while UI is switched off.
- Improved battery charge indication on LEDs-

[1.0.1.0]
- Added support for the CRMX Toolbox app to link/unlink
- Fixed bug that could cause the changing of PIN code to fail
- Fixed local DMX output at XLR from BLE service when in RX mode (allowing direct app control of a fixture).

[1.0.0.8]
- Firmware update is now faster
- Updated charging indication

[1.0.0.7]
- First production release
