v1.1.0.0 (2022-03-06)
=====================
* Added support for CRMX2
* Added support for Linking key via SPI
* Universe name is available on SPI interface
* Added support for receivig W-DMX G5 protocol
* Improved reception of W-DMX G4S potocol

v1.0.10.0 (2020-10-23)
======================
* Fixed an issue when using DMX streams with refresh rates above 200Hz.
* Improved DMX timing recreation.

v1.0.9.0 (2020-02-20)
=====================
* Added PRODUCT_ID SPI register
* Added RDM over SPI feature for TiMo RX RDM and TiMo FX is receiver mode
* Fixed bug that caused output power to be too low after switching from RX mode to TX mode without rebooting
* Fixed bug that caused receiver sensitivity to be too low after switching to RX mode from TX mdoe without rebooting
* Fixed bug for TiMo FX in TX mode that caused DMX with no interslot spacing to cause a drop in signal quality. 

v1.0.8.0 (2019-08-07)
=====================
* Detection of other wireless traffic improved for coexistence.
* Fixed bug where radio could become active even though it has been disabled from SPI.
* Added support for universe color coding on SPI.
* Added support for TiMo FX in TX mode to broadcast identify to all receivers.

v1.0.6.0 (2018-02-27)
=====================
* Added support for alternate start codes (ACS) in USB TX
* Fixed that SPI command NOP returned the wrong register if send directly after boot
* Fixed issue with RDM LED not flashing

v1.0.5.0 (2017-10-18)
=====================
* Improved DMX sync when using DMX over SPI in RX devices
* Improved DMX sync for TiMo FX
* Fixed issue where RX-only devices could be configured as TX, and end up in a non-operating state.

v1.0.4.0 (2017-03-05)
=====================
* Added support for dongle identity in Enttec protocol for Nova USB TX
* Fixed issue with some TiMo devices showing an RDM UID of 4C55:12345678.
* Fixed an issue that caused DMX to not be synchronised with some DMX sources.

v1.0.4.0 (2017-03-05)
=====================
* Added support for RDMchip
* Added support in TX mode for linking via SPI.

v1.0.3.6 (2016-10-25)
=====================
* Fixed USB TX compatability issue with Martin M-PC causing limited refresh rate.

v1.0.3.4 (2016-05-19)
=====================
* Added support for the Nova USB TX
* Improved coexistence for TX mode operation.

v1.0.3.0 (2015-07-16)
=====================
* Added support for TiMo FX

v1.0.2.0 (2015-05-19)
=====================
* Adjusted DMX sync tolerance
* Resolved issue where UART output could not always be disabled.
* Resolved issue where UART configuration bits in SPI register did not reflect the true state of the configuration.

v1.0.1.3 (2014-10-17)
=====================
* Added support for TiMo RX RDM
* Added support for CRMXchip-10H.

v1.0.0.5 (2014-05-27)
=====================
* Improved speed of re-establishing link. 
* Resolved issue where chip sometimes could not be unlinked.

v1.0.0.2 (2014-04-30)
=====================
* Resolved issue where framing error could happen under some circumstances

v1.0.0.0 (2014-04-14)
=====================
* Initial version for CRMXchip

